Parameter
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
RESTORER
MULTEQ
SURR. PARA
DYNAMIC VOLUME
[Front]
[NIGHT]
uio p
DYNAMIC
VOLUME
[SOURCE
CONTROL 1]
RESTORER
MULTEQ
Adjusting the Parameters
1
SURR. PARA
Press
BUTTON
Parameter is displayed.
<BUTTON>
b To operate from the remote control unit, be sure to set the
[BUTTON]
[SOURCE CONTROL 1]
2
Use
ui
to select which parameters to adjust.
Only those parameters which can be adjusted under the current
playback status are displayed.
3
o p
Use
to adjust the parameters.
Repeat steps 2 and 3 to set each parameter.
n To exit adjustment
SURR. PARA
• Press
• If no adjustment is made for a period of about 5 seconds, the
adjustments made up that point are registered and the AVR-589
returns to the original mode.
o p
ui
[Rear]
[CINEMA]
[MUSIC]
SURR. PARA
uiop
.
to "AUDIO".
during adjustment.
Surround Parameter
Adjust surround sound parameters.
The parameters (items) which can be adjusted differ
depending upon the following conditions.
• Whether an input signal is present (when playing) or not
(when stopped, etc.).
• The type of input signal
• The type of surround mode
For details of which parameters can be adjusted in each
surround mode, see "Surround Modes and Parameters"
(vpage 41, 42).
a Mode
s Cinema EQ
d D. Comp (Dynamic Range Compression)
f LFE
g Center Image
h Panorama
j Dimension
k Center Width
l Delay Time
A0 Effect Level
A1 Room Size
A2 SW ATT (Subwoofer Attenuation)
A3 Subwoofer
A4 Tone Control
A5 Bass
A6 Treble
A7 MultEQ
A8 Dynamic EQ
A9 Dynamic Volume
S0 DV Setting (Dynamic Volume Setting)
S1 RESTORER
S2 Night Mode
S3 Default
Need help?
Do you have a question about the AVR-589 and is the answer not in the manual?